4/30/2023 0 Comments Pocket screw directionThe drill bit is set with the most common material thickness of 1/2″, 3/4″ (for a 1x board) and 1 1/2″ (for a 2x board). What if you have a different material thickness then whats on the drill bit? When you add the stop collar to the drill bit, all you have to do is line up the material thickness indicator you need in the collar window and secure it with the hex wrench on the side of the material thickness gauge. And the stop collar has a window on it so you can see the material thickness through it. The drill bit has the material thickness indicators right on the side of it. The new drill bit might look a little familiar if you saw my previous post about the 300 series pocket hole jigs that were released just over a year ago. Refer to the section below titled “What if you have different material thicknesses then on the drill bit?” to learn how to micro adjust the 720 pocket hole jig.Īlso, the side and end of the material thickness gauge also has a hex wrench that is used to loosen/tighten the stop collar on your drill bit! Easy to Adjust Drill Bit.Set your drill bit for 3/4″ thick material and use 1 1/2″ long screws (instead of 1 1/4″ that are normally used for 3/4″ thick material).You have two choices if you material falls in the “book with i” section: But you can still use the new Kreg jig for your pocket holes. But if your material falls in the “book with an i” range, then that means your material is not one of the standard thicknesses.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |